| |
|
|
 |
|
| |
|
|
| |
|
|
 |
How do I find the Serial No.
Of the System or Parts? |
|
|
|
I just got
a new computer, what should I do? |
|
|
|
My system
has "No Display", What should I do? |
|
|
|
I've replaced a Octek
mother board in my system, and all CDs works fine except the "Octek
Recovery CD", the CD ROM is definitely works fine, can you tell me why? |
|
|
|
What is the
instruction of the OCTEK recovery CD
(XP)? |
|
|
|
How to solve Performance Problems and
Device & Driver Problems?
|
|
|
|
I have just re-install Windows in my System. The main board is VIA
chipset. It frequently locks up. It beings up with blue screen
during system shutdown, or Windows Protection errors when the system
start-up sometimes. |
|
|
|
Why
doesn't CMOS retain its settings? |
|
|
|
I have following error message when
the PC is turned on: BIOS
ROM Checksum error
Detecting floppy drive A media...
INSERT SYSTEM DISK AND PRESS ENTER
What should I do? |
|
|
|
My system
has Rhino Board inside. How can I turn the system off when I shutdown
Windows XP? |
|
|
|
My system
has Rhino Board inside. How can I turn the system off when I shutdown
Windows 2000? |
|
|
|
My system
has Rhino Board inside. How can I turn the system off when I shutdown
Windows 98? |
|
|
|
I have a
Octek system, the system has an internal modem, a network card, a video
card an Aureal Sound card, now I want to put a second printer card, but it
looks like I have run out of IRQs. |
|
|
|
I just
upgraded my system with new Rhino board. When I boot up my new computer
I got "floppy boot failure" and the LED on the floppy stays on.
|
|
|
|
After I
installed my AGP card driver, my system (with VIA Main board) frequently hangs up. Why?
|
|
|
|
My system
hangs up when running the program or OS. How should I do the
troubleshooting? |
|
|
|
How come I
can not install correspond driver for relate device? |
|
|
|
My system
runs too slowly. How can I speed it up? |
|
|
|
My system
works, but performance seems sluggish. If I check my "System" control
panel and look at the "Performance" section, it says that the IDE
controllers are working in "DOS Compatibility Mode" and that 32-bit file
system access and 32-bit virtual memory are not available. Then I look
at the "Device Manager" section and it has little yellow exclamation
marks next to the IDE driver entries. I can't figure out what to do
about this. What is happening here? |
|
|
|
How do I find out the version of
device driver? |
|
|
|
Why does
my computer hang after power up? |
|
|
|
Which operating systems
are optimized for Hyper-Threading Technology? |
|
|
|
Why can’t I enable Hyper-Threading Technology? |
|
|
|
I have a
brand new system, when I turn it on, only 3 short and 1 long beeps, and
it has no display. The system has an AGP card, is it faulty?
|
|
|
|
It seems be a problem with my Netcomm
Internal Modem. Sometimes no dial tone, sometimes dropping line. Is my
modem faulty? |
|
|
|
The Dimension of Power
Supplies |
|
|
|
How do I configure my computer to
generate an error report in complete memory dump file format when a Stop
error occurs? |
|
|
|
| Why does my system only
recognize 32 GB? |
|
|
|
|
The operating system only recognizes
128 GB or 137 GB of my large capacity drive. |
|
|
|
My BIOS has been
updated, but I still have problem to access the Hard Drive over
137GB Limit. Why? |
|
|
|
How do I diagnostic the RAM problem? |
|
| |
|
|
| |
|
|
| |
|
|
